模具英文141-150

2019-10-16 12:32:1101:35 562

声音简介

1．需要加热的模具，必须有隔热板。
Mould requiring heating should have insulator plate.

2．模具最好能自动生产，模具尽可能自断水口。
Mould preferred to run automatic; self-degating whenever possible.

3．模具必须稳定位置如有凸出物请加脚座，是否完成？
No obstructions on bottom surface of mold？

4．模坯长宽和模厚（模架的长宽）
Overall mold size of the moldbase & shut height

5．出入水位有否打上IN 、OUT 字码？
Outlets accessible and marked " IN OUT and NUMBER"？

6．画出突出部件并做好保护。
Protruding items shown and protected。

7．合模分布在合理可接受的表面。
Parting line at the acceptable surface.

8．尽可能布置多的运水。
Put waterline as much as possible/wherever possible。

9．尽可能在行位、斜、镶件布置运水。
Put waterline for slide /lifter/insert wherever possible.

10．分模线是否正确?
Parting line cleared and released properly?