模具英文46-50

2021-11-04 02:56:5801:07 1159

声音简介

1．产品粘母模的機會很大，能否在公模加倒勾，拉料頂針或者公模保留E.D.M紋，開模時使成品留在公模一側
There is possible sticking on cavity; therefore, please confirm whether it can make undercuts, snatch pins or leave coarse E.D.M. on the core to snatch the part on

2．此處料厚段差很大，成品表面會有應力痕，是否接受?
Please confirm whether it is acceptable to have stress lines on the surface because the thickness is not equal.

3．請注明何處為外觀面，能否提供2D圖和注意事項.
Please advise where the critical surface is. Please also provide us a 2D drawing with critical dimensions.

4．紅色所示處是有問題的地方，請特別注意
Please note the red highlights because those areas have problems.

5．成品設計此處有問題，建議如下圖所示修改
We would suggest using the attached part design， as the current design has problems.