模具英文66-70

2021-11-04 03:01:0701:16 1025

声音简介

1．成型後SUB GATE要修平
The gate (sub gate) needs to be trimmed evenly after being moulded.

2．此處倒勾先垂直頂出，之後再手動取出
This area of the undercut needs to be ejected vertically, then taken out manually.

67. 這兩個面都有滑塊，GATE改在此處改不到
The gate is not suitable in this area because there are two sliding blocks sealing off this area.

3．此處加做一個旋轉GATE，射出時方便調整成品的品質
We would suggest placing a runner shut-off insert to adjust the volume of part filling.

4．此倒勾在滑塊上強迫脫模，倒勾是否可以減小到0.6
This undercut will be force ejected out, Please confirm whether it can be reduced to 0.6 mm.

5．此柱子無法脫模，請確認是否是在轉圖時錯位，能否提供客戶的原始圖檔 data.
This boss is not releasable. Please check the file again ，and if possible, pleas re-send us the original draft.