声音简介
This rib will have a shrink problem because it is too thick.
2. 此處倒勾出模困難,建議先不做倒勾,成型後再二次加工,但要做治具,費用要另外算
There are problems with this current design, we recommend doing this undercut as an alternative but there will be additional costs.
3. 柱子底部都要做火山口
The base of all bosses require a crater to avoid shrinkage.
4. 镶件,P.L.面有充足排气坑,P.L.面要开环形排气槽,并能将气体排到模外。
Insert/PL should have adequate venting, PL should have around slot for venting.
5. 顶棍孔镶件端面距离底板面0,5mm,攻m20牙;
the surface of KO insert should below bottom plate 0.5mm,thread M20.
6. 回针,中托司与模胚部份避空0.5mm;
RP,EGP should have 0.5mm gap with the mold base.
7. 排气槽距封胶位10-15mm;
Venting slot distance, from the seal off position ,10-15mm
8. 运水进用 E ,运水出用 S ;
In take "E", Out take "S"
9. 底面板均要有隔热板,DME规格1/4厚;
Top/Bottom plate must have insulator plate, DME standard 1/4'H
10. 吊环要在模具的重心(保证吊模时的平衡);
Eyebolt should on the center of the mold(for balance)
11.
音频列表
- 2019-08
- 2019-07
- 2019-07
- 2019-07
- 2019-07
- 2019-07
- 2019-07
- 2019-07
- 2019-06
- 2019-06
查看更多
用户评论